Video Camera Reference Kit – INP1014/15
High-end camera/doorbell, edge AI, 4K resolution, 2-4x battery life
The T41+Talaria TWO platform is suitable for high-end 4K video camera with AI processing. The platform incorporates the Dual-Stack software architecture to extend the battery-life performance, by offloading the cloud connectivity Keep Alive (KA) messages and local sensor interfacing to Talaria TWO. The platform supports Ingenic’s T41 Indus Evaluation Kit and InnoPhase IoT’s Talaria TWO Wi-Fi/BLE daughter card for rapid prototyping and evaluation.
Technical Specification
Hardware
Talaria TWO INP1014 Module
- Wi-Fi: 802.11 b/g/n, up to MCS7 2.4 GHz, Single-stream (1x1)
- BLE: BLE 5.0 w/ Advanced Features: 2Mbps PHY, LE Coding (Long-Range), Extended Advertising
- Application Processor: Arm Cortex-M3, 80MHz
- Embedded Memories: 512KB SRAM, 2MB Flash
- Peripheral Interface to T31: SDIO
- Ultra-Low Power Wi-Fi: 57uA (DTIM10), 31mA (Rx, 11b), 81mA (Tx, 802.11n)
Ingenic T41Z ISP
- CPU: Dual-Core @1.4GHz, RISC-V independent lite core
- Video Encoder: H.264/H.265/MJPEG encoder, Maximum 3840*2160@20fps
- Starlight ISP: Dedicated optimizations for low light and surveillance scenarios, Upgraded 2D / 3D noise reduction, Distortion correction
- Magik AI Algorithm: Supports deep learning algorithms with high precision and good flexibility - Human detection, Facial detection/recognition, Cry detection, Vehicle detection, Pet detection
- Memory: Capacity of 512Mbit or 1Gbit
- Audio: Integrated Audio Codec, Support I2S Interface, Echo cancellation
Both:
- 1080P CMOS Image Sensor
- Microphone & Speakers
- PIR Sensor
- LEDs & Push-button
- Power Supply Options:
- USB-C connector
- Battery connector
- On-board power measurement test points
- Debug connectors for programming Talaria TWO
Software
- Talaria TWO SDK with dual-stack
- Talaria TWO offloads cloud Keep-Alive messages & interfaces to sensors.
- Ingenic T41Z is shutdown for extended battery-life performance
- T41Z Linux drivers and Wi-Fi connection manager
- Video Streaming reference application
- AWS Kinesis Cloud Connectivity
- Android Mobile App
- Device Provisioning over BLE
- Firmware Updates:
- Firmware Over-the-Air (FOTA) over Wi-Fi
- Firmware Over-Serial (FOS) from Ingenic T31ZX host
